200-301 Exam Dumps - Implementing and Administering Cisco Solutions (200-301 CCNA) v1.1

Searching for workable clues to ace the Cisco 200-301 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s 200-301 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:

Question # 225

Why was the RFC 1918 address space defined?

conserve public IPv4 addressing

preserve public IPv6 address space

reduce instances of overlapping IP addresses

support the NAT protocol

Full Access

Question # 226

Which implementation provides the strongest encryption combination for the wireless environment?

WPA2 + AES

WPA + AES

WEP

WPA + TKIP

Full Access

Question # 227

How does encryption project the wireless network?

via integrity checks to identify wireless forgery attacks in the frame

via specific ciphers to detect and prevent zero-day network attacks

via an algorithm to change wireless data so that only the access point and client understand it

via a policy to prevent unauthorized users from communicating on the wireless network

Full Access

Question # 228

Refer to the exhibit.

Switch A is newly configured. All VLANs are present in the VLAN database. The IP phone and PC A on Gi0/1 must be configured for the appropriate VLANs to establish connectivity between the PCs. Which command set fulfills the requirement?

Option A

Option B

Option C

Option D

Full Access

Question # 229

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

lldp timer

lldp holdtimt

lldp reinit

lldp tlv-select

Full Access

Question # 230

Which network action occurs within the data plane?

compare the destination IP address to the IP routing table.

run routing protocols (OSPF, EIGRP, RIP, BGP)

make a configuration change from an incoming NETCONF RPC

reply to an incoming ICMP echo request

Full Access

Question # 231

Refer to the exhibit. An engineer configured the New York router with static routes that point to the Atlanta and Washington sites. Which command must be configured on the Atlanta and Washington routers so that both sites are able to reach the Lo2 interface on the New York router?

ipv6 route ::/0 Serial 0/0/0

ipv6 route 0.0.0.0 0.0.0.0 Serial 0/0/0

ipv6 route ::/0 2000::2

ipv6 route ::/0 Serial 0/0/1

Full Access

Question # 232

What is a difference between local AP mode and FiexConnet AP mode?

Local AP mode creates two CAPWAP tunnels per AP to the WLC

FiexConnect AP mode fails to function if the AP loses connectivity with the WLC

FlexConnect AP mode bridges the traffic from the AP to the WLC when local switching is configured

Local AP mode causes the AP to behave as if it were an autonomous AP

Full Access