350-501 Exam Dumps - Implementing and Operating Cisco Service Provider Network Core Technologies (350-501 SPCOR)
Searching for workable clues to ace the Cisco 350-501 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s 350-501 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps
An engineer working for a private telecommunication company with an employe id:3948:613 needs to limit the malicious traffic on their network. Which configuration must the engineer use to implement URPF loose mode on the GigabitEthernet0/1 interface?
A)
B)
C)
D)
A network administrator is planning a new network with a segment-routing architecture using a distributed control plane. How is routing information distributed on such a network?
Refer to the exhibit. ISP_A is a Tier-1 ISP that provides private Layer 2 and Layer 3 VPN services across the globe using an MPLS-enabled backbone network. Routers R1, R2, R13, and R14 are PE devices. ASRs R3 and R4 and ASBRs R11 and R12 are acting as route reflectors with preconfigured next-hop-self for all BGP neighbors. After the network experienced IGP RIB overflow with multiple routes, a network engineer is working on a more scalable network design to minimize the impact on local RIBs. The solution should be based on RFC 3107 and maintain existing QoS capabilities.
Which task must the engineer perform to achieve the goal?
Refer to the exhibit. A company recently deployed a new network using OSPF in the core to share routes. The network administrator selected OSPF as the routing protocol because of its ability to maintain a route database. When the new network was started up, all routers booted normally, but the link between routers R1 and R2 failed to come up. The two routers are located in the same rack at the data center. Which task should an engineer perform to correct the problem?
Refer to the exhibit. A Tier-2 ISP provides MPLS Layer 3 VPNs to customers throughout the region. BGP and OSPF are used as routing protocols in the backbone, and all routers are running Cisco IOS-XE software. Customer A has requested a private connection between two of its offices. The company has plans to interconnect more offices across the country soon, so the solution should allow for the addition of new sites without reconfiguring the existing sites. The customer is using an IPv6 addressing scheme. R1 has been preconfigured with vrf definition Customer_A and assigned rd 1441:3421.
Which two tasks should the engineer perform on R1 to configure the private connection? (Choose two.)
Refer to the exhibit. A network operator is attempting to configure an IS-IS adjacency between two routers, but the adjacency cannot be established. To troubleshoot the problem, the operator collects this debugging output. Which interface are misconfigured on these routers?
