Summer Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

300-815 Exam Dumps - Implementing Cisco Advanced Call Control and Mobility Services (CLACCM)

Go to page:
Question # 33

Refer to the exhibit.

An administrator is troubleshooting a problem in which some outbound calls from an internal network to the Internet telephony service provider are not getting connected, but some others connect successfully. The firewall team found that some call attempts on port 5060 came from an unrecognized IP that has not been defined in the firewall rule. What should the administrator configure in the Cisco Unified Border Element to fix this issue?

A.

use of port 5061 for SIP secure

B.

access list allowing the firewall IP

C.

ip prefix-list to filter the unwanted IP address

D.

bind signaling and media to the loopback interface

Full Access
Question # 34

Users in a small location report that audio calls work Tine, but only one video call works before the next one gets a busy signal. Three video conference rooms were recently installed by a third party. The audio and video devices are Cisco endpoints. The site uses video and audio calls, and a network investigation does not show saturation on the link The site is configured with QoS and CoS. All devices are registered on the headquarters Cisco UCM duster. What is the cause of this problem?

A.

The subzone setting for video is too low.

B.

The zone settings for video are too low.

C.

The location setting for video is too low.

D.

The pipe or link configuration for video is set to only one device.

Full Access
Question # 35

Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?

A.

System > Location Info

B.

Call Routing > Route/Hunt > Local Route Group Names

C.

System > Device Pool

D.

Call Routing > Emergency Location > Emergency Location (ELIN) Groups

Full Access
Question # 36

Refer to the exhibit.

A user dials 84969010 and observes that the call is not routed immediately. The administrator notices that after matching the fixed-length translation pattern, the call hits the \+! pattern and waits for interdigit timeout What should be configured to ensure that the call routes out immediately?

A.

Allow Device Override on the route pattern

B.

Route Next Hop By Calling Party Number on the translation pattern

C.

Do Not Wait For Interdigit Timeout On Subsequent Hops on the translation pattern

D.

Do Not Wait For Interdigit Timeout On Subsequent Hops on the route pattern

Full Access
Question # 37

An administrator troubleshoots call failure in a new deployment and finds that the SIP INVITE messages sent to the service provider contain a diversion header with the user's 4-digit directory number. These 4-digit directory numbers range from 1000 to 9999. The service provider is rejecting the calls because it requires that the diversion header contain 10 digits. Which command on the Cisco Unified Border Element resolves this issue for all users?

A)

B)

C)

D)

A.

Option A

B.

Option B

C.

Option C

D.

Option D

Full Access
Question # 38

How does an engineer globalize routing for ingress calls coming from the PSTN to internal DNs?

A.

At the PSTN gateway, put the calling number in PSTN format and the called number in DN format.

B.

At Cisco Unified CM, put the calling number in E.164 format and the called number in PSTN format.

C.

At the PSTN gateway, put the calling number in E.164 format and the called number in localized (DN) format.

D.

At Cisco Unified Communications Manager, put the calling number in E.164 format and the called number in E.164 format.

Full Access
Question # 39

Refer to the exhibit. An engineer is troubleshooting an issue where inbound Calls are failing after they transferred. The provider reports that update is not supported, and this is causing the calls to fail. Which command should resolve this issue?

A.

no midcall-signaling passthru

B.

no update-callerId

C.

no contact-passig

D.

rel1xx require “100rel”

Full Access
Question # 40

The administrator of ABC company is troubleshooting a one-way audio issue for a call that uses H.323 protocol (slow-start mode). The administrator requests that you provide the IP and port information of the Real- Time Transport Protocol traffic that had the one-way audio call.

You gather the H.225 and H.245 messages for one of the one-way audio calls. Where can you find the RTP IP and port information for both sides? (Note: This call flow has not invoked any media resources like MTP or transcoders).

A.

H.245 Terminal Capability Set

B.

H.245 Open Logical Channel

C.

H.225 Connect

D.

H.245 Open Logical Channel Ack

Full Access
Go to page: