300-410 Exam Dumps - Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)

Searching for workable clues to ace the Cisco 300-410 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s 300-410 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:

Question # 185

Refer to the exhibit.

Reachability between servers in a network deployed with DHCPv6 is unstable. Which command must be removed from the configuration to make DHCPv6 function?

ipv6 dhcp server DHCPPOOL

ipv6 address 2001:0:1:4::/64

ipv6 nd ra suppress

address prefix 2001:0:1:4::/64 lifetime infinite infinite

Full Access

Question # 186

Refer to the exhibit.

An engineer configured IP SLA to monitor a next hop on a router for reachability When the next hop is unreachable, the router is executing tracking and failing over another route, but packet loss is experienced because the reachability is flapping. Which action resolves the issue?

Append delay up 0 down Ovto the track command

Increase the timeout of the sla probe to 6000

Append delay up SO down 60vto the track command

Increase the frequency of the sla probe to 60.

Full Access

Question # 187

Refer to the exhibit.

An administrator is troubleshooting a time synchronization problem for the router time to another Cisco IOS XE-based device that has recently undergone hardening. Which action resolves the issue?

Allow NTP in the ingress ACL on 10.1.225.40 by permitting UDP destined to port 123.

Ensure that he CPE router has a valid route to 10.1.255. 40 for NTP and rectify if not reachable.

NTP service is disabled and must be enabled on 10.1.225.40.

Allow NTP in the ingress ACL on 10.1.255.40 by permitting TCP destined to port 123.

Full Access

Question # 188

:582

Refer to the exhibit. Branch 2 hosts cannot receive dynamic IP addresses. Which action resolves the issue?

Configure the ip helper command on the interface GigabitEthernet 0/2 of the R2 router

Configure the Ip helper command on the Layer 2 switch SW2 interfaces

Configure the Ip helper command on the interface GigabitEthernet 0/2 of the DHCP router.

Configure the Ip helper command on the interface GigabitEthernet 0/0 of the DHCP router.

Full Access

Question # 189

Refer to the exhibit.

The network administrator must configure Cape Town to reach Dubai via Tokyo based on the speeds provided by the service provider. It was noticed that Cape Town is reaching Dubai directly and failed to meet the requirement. Which configuration fixes the issue?