300-410 Exam Dumps - Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)

Add the aaa authentication login default none command to the global configuration.

Replace the capital “C” with a lowercase “c” in the aaa authentication login Console local command.

Add the aaa authentication login default group tacacs+ local-case command to the globalconfiguration.

Add the login authentication Console command to the line configuration

20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL

32-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL

20-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit

32-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit

Enter the service timestamps log datetime localtime global command.

Enter the service timestamps log datetime synchronize global command.

Enter the service timestamps log datetime console global command.

Enter the service timestamps log datetime clock-period global command

IPv6 Source Guard

IPv6 Destination Guard

IPv6 Prefix Guard

Binding Table Recovery

Modify the flow transport command transport udp 2055 to move under flow monitor profile.

Modify the interlace command to Ip flow monitor FLOW-MONITOR-1 Input.

Modify the udp port under flow exporter profile to Ip transport udp 4739.

Modify the flow record command record v4_r1 to move under flow exporter profile.

NYrouter ospf 1area 0 authentication message-digest

LAinterface E 0/0ip ospf message-digest-key 1 md5 Cisco123

NYinterface E 0/0no ip ospf message-digest-key 1 md5 Cisco123ip ospf authentication-key Cisco123

LAinterface E 0/0ip ospf authentication-key Cisco123

LArouter ospf 1area 0 authentication message-digest

The label edge router swaps labels on the received packets.

Labels are imposed in packets after the Layer 3 header.

LDP uses TCP for reliable delivery of information.

An MPLS label is a short identifier that identifies a forwarding equivalence class.

A maximum of two labels can be imposed on an MPLS packet.