F5CAB3 Exam Dumps - BIG-IP Administration Data Plane Configuration (F5CAB3) exam

The log message " aggressive mode activated " indicates that the BIG-IP ' s adaptive connection management system (the " Sweeper " ) has detected that the system ' s memory or connection limits are reaching a critical threshold. To protect the system from crashing due to memory exhaustion (OOM), the BIG-IP enters Aggressive Mode, where it begins to proactively and rapidly reap (close) idle connections to free up resources for new incoming traffic.

To mitigate this and return the system to a healthy state, the administrator needs to reduce the overall resource footprint of existing connections. Decreasing the TCP profile Idle Timeout value (Option B) is the most effective administrative action. In many environments, the default idle timeout is 300 seconds (5 minutes). If a large number of connections remain " open " in the BIG-IP connection table long after the clients have stopped sending data, they consume valuable TMM (Traffic Management Microkernel) memory. By lowering the timeout (e.g., to 60 or 120 seconds), the BIG-IP can expire and remove these inactive entries much sooner, preventing the connection table from bloating and triggering the Sweeper ' s aggressive mode.

Conversely, increasing the timeout (Option C) would exacerbate the problem by keeping " dead " connections in memory even longer. Connection Mirroring (Option D) actually increases memory usage because every connection must be duplicated on the standby peer. An active-active configuration (Option A) might spread the load but does not address the underlying resource management issue on the individual units. Therefore, tightening the idle timers is the standard procedural fix for memory pressure caused by high connection volumes.