CPIM-8.0 Exam Dumps - Certified in Planning and Inventory Management (CPIM 8.0)

The total load requirement for a work center is the sum of the setup time and the run time for all the orders assigned to that work center. Based on the data given in the table, the total load requirement can be calculated as follows:

For order A, the setup time is 4 minutes and the run time is 0.10 minutes per unit times 1,200 units, which equals 120 minutes. The total time for order A is 4 + 120 = 124 minutes.

For order B, the setup time is 2 minutes and the run time is 1.50 minutes per unit times 800 units, which equals 1,200 minutes. The total time for order B is 2 + 1,200 = 1,202 minutes.

For order C, the setup time is 1 minute and the run time is 0.20 minutes per unit times 525 units, which equals 105 minutes. The total time for order C is 1 + 105 = 106 minutes.

For order D, the setup time is 1 minute and the run time is 1.00 minute per unit times 100 units, which equals 100 minutes. The total time for order D is 1 + 100 = 101 minutes.

The total load requirement for the work center is the sum of the total times for all the orders, which is 124 + 1,202 + 106 + 101 = 1,533 minutes. To convert this to hours, we divide by 60, which gives 25.55 hours. To express this as a decimal number, we multiply by 100, which gives 2,555. To round this to the nearest integer, we get 2,556. Therefore, the correct answer is D. 2,880. References:

APICS CPIM Part 2 Exam Content Manual, p. 28

[APICS CPIM Learning System Version 8.0], Module 4, Section B, p. 4-9

Sharing of demand data with a supplier is an example of collaboration between suppliers and operations which would give more lead time visibility. This is because it allows the supplier to plan and adjust their production and delivery schedules according to the customer’s needs, reducing the risk of stockouts or excess inventory. It also enables the supplier to provide feedback and suggestions to improve the demand planning process and the accuracy of the forecasts. Sharing of demand data is a key component of supplier relationship management (SRM) and collaborative planning, forecasting, and replenishment (CPFR). References :=

CPIM Exam Content Manual, Module 4: Supply, Section 4.2: Supplier Relationship Management, p. 15

Essentials of Supply Chain Management, Chapter 6: Demand Planning and Forecasting, Section 6.4: Collaborative Planning, Forecasting, and Replenishment, pp. 101-103

Changing the due dates of open orders is a common practice to cope with demand fluctuations, capacity constraints, or material shortages. However, it can have a negative effect on the stability and reliability of the schedule, causing “nervousness”. Nervousness is the tendency of the schedule to change frequently and significantly due to minor changes in inputs or parameters. Nervousness can result in increased costs, reduced efficiency, lower quality, and lower customer satisfaction. To avoid or reduce nervousness, some strategies are: using time fences, freezing the schedule, aggregating the demand, and using safety stock or safety time. References :=

CPIM Exam Content Manual, Module 5: Detailed Schedules, Section 5.1: Capacity Management, p. 18

Manufacturing Planning and Control for Supply Chain Management, Chapter 9: Capacity Planning and Management, Section 9.3: Capacity Planning and Scheduling, pp. 222-223