Summer Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

350-801 Exam Dumps - Implementing Cisco Collaboration Core Technologies (350-801 CLCOR)

Go to page:
Question # 4

Refer to the exhibit. An engineer is troubleshooting this video conference issue:

*A video call between a Cisco 9971 in Region1 and another Cisco 9971 in Region1 works.

*As soon as the Cisco 9971 in Region1 conferences in a Cisco 8945 in Region2. the Regio1l endpoint cannot see the Region2 endpoint video.

What is the cause of this issue?

A.

Maximum Audio Bit Rate must be increased.

B.

Maximum Session Bit Rate for Immersive Video Calls is too low.

C.

Maximum Session Bit Rate for Video Calls is too low.

D.

Cisco 8945 does not have a camera connected.

Full Access
Question # 5

What are two functions of Cisco Expressway in the Collaboration Edge? (Choose two.)

A.

Expressway-C provides encryption (or Mobile and Remote Access but not (or business-to-business communications.

B.

The Expressway-C and Expressway-E pair can enable connectivity from the corporate network to the PSTN via a T1/E1 trunk.

C.

The Expressway-C and Expressway-E pair can interconnect H.323-to-SIP calls for voice.

D.

Expressway-E provides a VPN entry point for Cisco IP phones with a Cisco AnyConnect client using authentication based on certificates.

E.

Expressway-E provides a perimeter network that separates the enterprise network from the Internet.

Full Access
Question # 6

Users dial a 9 before a 10-digit phone number to make an off-net call All 11 digits are sent to the Cisco Unified Border Element before going out to the PSTN The PSTN provider accepts only 10 digits. Which configuration is needed on the Cisco Unified Border Element for calls to be successful?

A.

voice translation-rule 1 rule 1 /^9/ //

B.

voice translation-rule 1 rule 1 /^9(..........)/ //

C.

voice translation-rule 1 rule 1 /^9.+/ //

D.

voice translation-rule 1 rule 1 /^9........./ //

Full Access
Question # 7

Refer to the exhibit. What is the registration state of the analog port in this debug output?

A.

The analog port failed to register to Cisco UCM with an error code 200.

B.

The MGCP Gateway is not communicating with the Cisco UCM.

C.

The analog port is currently shut down.

D.

The analog port is registered to Cisco UCM.

Full Access
Question # 8

Refer to the exhibit. An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is used?

A.

G711alaw

B.

No codec is used (missing codec command)

C.

G.711ulaw

D.

G729r8

Full Access
Go to page: