Spring Sale Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

350-801 Exam Dumps - Implementing Cisco Collaboration Core Technologies (350-801 CLCOR)

Searching for workable clues to ace the Cisco 350-801 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s 350-801 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:
Question # 17

What requires a Cisco IOS XE transcoder?

A.

DTMF conversion

B.

SIP early offer

C.

transrating

D.

call queuing

Full Access
Question # 18

An administrator is adding regions in Cisco UCM. Which codec(s) are selected when a call is placed if the max audio bit rate used is 8 kbps?

A.

G.729

B.

G.722

C.

G.729 and G.711ulaw

D.

G71lulawandG.711alaw

Full Access
Question # 19

Refer to the exhibit. An administrator accesses the terminal of a Cisco UCM and starts a packet capture. Which two commands must the administrator use on Cisco UCM to generate DNS traffic? (Choose two.)

A.

utils ntp status

B.

show cdp neighbor

C.

show version active

D.

utils diagnose test

E.

autils diagnose module validate Network

Full Access
Question # 20

After an engineer implements the FAC and CMC features together, users report that calls take almost one minute to complete and that they occasionally hear the reorder tone. Which two actions address this issue?( Choose two)

A.

Adjust the T302 timer from the default of 15 seconds to 5 seconds to shorten the interdigit timer

B.

Change the code if the problem persists

C.

Advise the user to hang up and try again

D.

Do not wait for the tones immediately dial the FAC and CMC

E.

Advise the user to press the"#"button after dialing the FAC and CMC codes

Full Access
Question # 21

Refer to the exhibit.

https://i.postimg.cc/C57TkczG/image.png

A call is falling to establish between two SIP Devices The called device answers with these SOP Which SOP parameter causes issue?

A.

The calling device did not offer a ptime value

B.

The media stream is set to send only

C.

The payload for G.711ulaw must be 18.

D.

The RTP port is set to 0.

Full Access
Question # 22

How does Cisco define jitter?

A.

voice packet loss that is greater than 1 %

B.

excessive network latency

C.

varying delay of received voice packets

D.

varying delay of sent voice packets

Full Access
Question # 23

An administrator is configuring a new Cisco UCM with PSTN capabilities. Due to

bandwidth constraints, audio compression is used on the codec. DTMF must work as

expected because the customer is calling many call centers where the users must select

options in the call. Where is DTMF out-of-band in a CCM 12.5 with SIP-based gateway

configured?

A.

in the DTMF setting under SIP profile on the Cisco Unified Border Element

B.

in the dial peer on the Cisco IOS router

C.

in regions on the Cisco UCM where the appropriate codec to use is set

D.

in DTMF settings in the audio codec preference list under regions in the Cisco UCM

Full Access
Question # 24

What is the maximum length of any phone number according to ITU recommendation E.164?

A.

10

B.

12

C.

15

D.

17

Full Access
Go to page: