Black Friday Countdown: 75% Off Exam Bundles! Use coupon code below before time runs out! - Ends in 0d 00h 00m 00s - Coupon code: 75vsure

350-801 Exam Dumps - Implementing Cisco Collaboration Core Technologies (350-801 CLCOR) v2.0

Searching for workable clues to ace the Cisco 350-801 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s 350-801 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:
Question # 33

An engineer deploys a Cisco Expressway-E server for a customer who wants to utilize all features on the server. Which feature does the engineer configure on the Expressway-E?

A.

H.323 endpoint registrations

B.

Mobile and Remote Access

C.

SIP gateway for PSTN providers

D.

VTC bridge

Full Access
Question # 34

A remote office has a less-than-optimal WAN connection and experiences packet loss, delay and jitter. Which VoIP codec is used in this situation?

A.

G722.1

B.

iLBC

C.

G.711alaw

D.

G.729A

Full Access
Question # 35

Which actions required for a firewall configuration on a Mobile and Remote Access

through Cisco Expressway deployment?

A.

The traversal zone on Expressway-c points to Expressway-e through the peer address field on the traversal zone, which specifies the Expressway-e server address. For dual NIC deployments, set the Expressway-e address using an FQDN that resolves the IP address of the internal interface

B.

The external firewall must allow these inbound connections to Expressway: SIP: TCP 5061; HTTPS: TCP 8443; XMPP TCP 5222; media: UDP 36002 to 59999

C.

Do not use a shared address for Expressway-e and Expressway-c, as the firewallcannot distinguish between them. If static NAT for IP addressing on Expressway-e is used, ensure that any NAT operation on expressway-c does not resolve the same traffic IP address. Shared NAT IS not supported

D.

The internal firewall must allow these inbound and outbound connections betweenexpressway - c and Expressway-e :sip;HTTPS(tunneled over SSH between C and E.TCP 2222: TCP 7001: Traversal Media: UDP 2776 to 2777(or 36000 to 36011 for large VM/appliance); XMPP:TCP 7400

Full Access
Question # 36

Where is it recommended to enforce the QoS trust boundary on a network?

A.

LAN access ingress and the WAN access ingress

B.

LAN access egress

C.

LAN access ingress

D.

LAN access egress and the WAN access egress

Full Access
Question # 37

Refer to the exhibit.

What is the reason for this call failure?

A.

The device pool contains more call processing agents in the CMG group than tie endpoint can support

B.

MRGL contains more media groups than the endpoint can support.

C.

The hunt group contains more devices than the endpoint can support

D.

The available location bandwidth between sites is exceeded

Full Access
Question # 38

What happens to voice packets from an 8845 Cisco IP Phone at a properly configured QoS trust boundary?

A.

The phone and access layer switch negotiate the classification of packets.

B.

Cisco UCM determines how the voice packets are classified.

C.

The voice packets are classified by the phone and the classification is accepted.

D.

The voice packets are not trusted, and the access layer switch reclassifies the packets.

Full Access
Question # 39

Which DSCP marking is represented as 101110 in an IP header?

A.

EF

B.

CS3

C.

AF41

D.

AF31

Full Access
Question # 40

An engineer must implement toll fraud prevention in Cisco LJCM. The engineer creates several new partitions and assigns them to directory numbers and patterns- mat must be created next to accomplish this task?

A.

Create calling search spaces and apply them to all devices.

B.

Create a SIP trunk security profile and apply it to the SIP trunks.

C.

Create calling search spaces and apply them to end users.

D.

Create secure SIP profiles and apply them to the SIP trunks.

Full Access
Go to page: