H31-341_V2.5 Exam Dumps - HCIP-Transmission V2.5

PWE3 specifies two CES emulation modes: Structure-Agnostic TDM over Packet (SAToP) and Structure-aware TDM Circuit Emulation Service over PSN (CESoPSN). Circuit Emulation over Packet (CEP) is not defined within PWE3.

It is false that output optical power of a site must be as high as possible to ensure signals reach the peer site. Excessively high output power can cause nonlinear effects, such as four-wave mixing and self-phase modulation, degrading signal quality. Optimal power levels must be maintained within equipment specifications to balance reach and signal integrity. HCIP-Transmission stresses careful power management, including gain control and attenuation, to maximize network performance without introducing impairments.

A parallel FOADM site typically uses an EX40+EMR8 networking mode, where EX40 handles add/drop functions and EMR8 manages multiplexing and amplification.

A VOA (Variable Optical Attenuator) is configured on each wavelength path of a WSS (Wavelength Selective Switch) board to adjust the power of optical signals. This power adjustment is crucial to achieve flatness across channels by compensating for varying signal intensities. Without such adjustment, some wavelengths may overpower others, causing nonlinear effects and signal degradation. The VOA ensures that all wavelength channels have balanced power levels, improving signal quality and network reliability. This principle is fundamental in dense WDM networks and is emphasized in HCIP-Transmission studies focusing on optical layer signal integrity and amplification management.

The DWSS20 board does not support grooming of 20-degree optical signals; it is designed for other signal types or degrees.

OTUk_LOM (Loss of Multiframe) alarm is generated when frame alignment is lost; however, the statement that it occurs when the Frame Alignment Signal (FAS) is Out of Frame (OOF) for three consecutive milliseconds is false. The actual time threshold differs slightly according to standards and vendor implementations. HCIP-Transmission clarifies these alarm thresholds and conditions to ensure precise timing in fault detection, avoiding false alarms while providing timely notifications for network maintenance.

The TMB1AST2 board is a specialized optical module used in transmission equipment. According to HCIP-Transmission references, all the statements about this board are correct. (A) The TM1 optical port must be connected to the TMI1 optical port for proper operation. (B) It supports IEEE 1588v2 clock processing, essential for precise time synchronization, and includes OTDR (Optical Time Domain Reflectometer) functions for fiber fault detection and maintenance. (C) When working with DFIU03/DFIU04 boards, the OSC optical port requires an optical module that supports the 1511 nm wavelength to ensure wavelength compatibility. (D) Similarly, when working with DSFIU01/DSFIU02 boards, the TM1/RM1 and TM2/RM2 ports must use optical modules supporting 1511 nm and 1491 nm wavelengths respectively, ensuring correct wavelength assignment for WDM channels. This detailed configuration ensures interoperability and proper system functionality.

With an initial RI1–RI2 difference of 2 dB and a 5 dB threshold, only when the active channel’s loss increases by 7 dB (to 3 dBm) while the standby remains at 8 dBm does the difference reach 5 dB and trigger switching.