Summer Sale Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: v4s65

CWDP-305 Exam Dumps - Certified Wireless Design Professional

Go to page:
Question # 65

Which one of the following might be detected as a source of CCI during a post-validation survey in the 5 GHz band?

A.

Other OFDM networks

B.

Other ERP networks

C.

Microwave ovens

D.

Other HR/DSSS networks

Full Access
Question # 66

Who should be in the final meeting from the customer-side after successfully implementing a WLAN infrastructure?

A.

CEO or CFO

B.

End-users

C.

The customer's customers

D.

Remote workers

Full Access
Question # 67

Given: The 802.11ac APs you have selected for your public access deployment support many of the PHY and MAC enhancements offered by the 802.11n and 802.11ac amendments. The AP is configured for a single-band (2.4 GHz) and only allows 20 MHz channels. The WLAN radio in the AP is a 3x3 802.11n chip that supports two spatial streams. What is the maximum MCS rate that could be supported by this AP?

A.

54 Mbps

B.

65 Mbps

C.

108 Mbps

D.

144 Mbps

Full Access
Question # 68

Your customer's 802.11n laptops cannot detect the SSID in the 5 GHz band in a conference room, but your 802.11ac laptop connects without issue. What is the most likely explanation for this discrepancy?

A.

The AP is configured to use channel 36

B.

The customer laptop does not support OFDM

C.

The AP is on channel 144

D.

Their laptops are SISO clients

Full Access
Question # 69

What statements are true regarding jitter and latency?(Choose all that apply.)

Response:

A.

Jitter is a measurement of latency variability from one frame to another.

B.

Jitter is a measurement of the variance of the number of frames received from an application for a specific time interval.

C.

Jitter is a measurement of average latency based on a sample of >100 frames.

D.

Latency is a measurement of the time delay experienced in the delivery of a frame.

E.

Latency is a measurement of the time required to transmit two subsequent frames.

Full Access
Question # 70

Given:For this fill-in-the-blank question, each answer option contains an answer for the first and second blanks, separated by a dash "—". Choose the answer option that correctly fills in both blanks in the following sentence.

A WLAN may use 802.11 admission control to ________, and admission control requirements are configured separately for each ________.

A.

Block stations with inadequate security parameters — SSID

B.

Identify voice-enabled wireless devices — AP radio (that is, 2.4 GHz or 5 GHz)

C.

Regulate the available bandwidth resources — Access Category

D.

Mark ingress and egress frames with priority values — TCP/IP port

Full Access
Question # 71

You are testing a VoWLAN deployment, and your communication measurements show a certain amount of lost packets. What would be an acceptable packet error rate value to still provide acceptable call quality?

A.

There should be 0% error in a VoWLAN type of deployment

B.

No more than 1% PER max should be acceptable

C.

No more than 4% PER max should be acceptable

D.

No more than 8% PER max should be acceptable

Full Access
Question # 72

When deploying APs outdoors, what additional component needs to be used that is not needed indoors?

A.

Antennas

B.

NEMA enclosures

C.

Ethernet cables

D.

PoE

Full Access
Go to page: