Weekend Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

CTS-I Exam Dumps - Certified Technology Specialist – Installation

Go to page:
Question # 137

When powering a system off, which device from the following list should you turn off first?

A.

Pre-amplifiers

B.

Wireless mic receivers

C.

Blu-ray players

D.

Power amplifiers

Full Access
Question # 138

Which of the following is a sign of active listening?

A.

Avoiding staring directly at the person speaking to you.

B.

Interrupting frequently to provide the customer with more information.

C.

Nodding to your customer so they know that you understand them.

D.

Wearing mirrored sunglasses so the customer can't see where you're looking.

Full Access
Question # 139

The best practice for mounting equipment in a rack is to:

A.

Mark RUs beside the mounting rail with a utility knife.

B.

Verify that the holes of the rear mounting rails are 1 inch (2.5 cm) higher than front rails.

C.

Lay the rack on its back on top of padding.

D.

Remove all clip nuts from the mounting rail to secure them to gear first

Full Access
Question # 140

Which of the following best describes an electret, when used in a microphone?

A.

a preconfigured capacitor

B.

a small battery

C.

prepolarized material

D.

a charged backplate

Full Access
Question # 141

Raised bumps on the head of a bolt indicate which of the following?

A.

Defect in manufacturing

B.

Length of bolt

C.

Grade of bolt

D.

Size of head

Full Access
Question # 142

Rear projection is a transmissive system that _____.

A.

requires little space for installation

B.

allows light to pass through a translucent screen toward the viewer

C.

handles ambient light issues more poorly than front screen projection

D.

can allow a presenter to block all or part of the image

Full Access
Question # 143

The impedance will _____ over the loudspeaker's entire frequency range.

A.

stabilize

B.

not be the same

C.

vary with strength

D.

be exactly the same

Full Access
Go to page: