Labour Day Sale Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

4A0-105 Exam Dumps - Nokia Virtual Private LAN Services

Question # 4

The service mtu of a VPLS is set to 9100. What is the recommended MTU value that can be set for the access port assuming dot1q encapsulation?

A.

9100

B.

9104

C.

9108

D.

9122

E.

9126

Full Access
Question # 5

Click on the exhibit below.

Based on the output below which of the following statements is true?

A.

This Bridge is furthest from the Root Bridge within the VPLS mesh.

B.

This Bridge is the Root Bridge.

C.

SAP 1/1/1 is an Edge Port.

D.

This Bridge is closest to the Root Bridge within the VPLS mesh.

Full Access
Question # 6

After the "disable-learning" command has been executed at the VPLS level, a new client device originates a frame. What is the result?

A.

If the MAC address of this new client device does not reach the upper limit of the configured total number of MAC addresses allowed in the VPLS forwarding database, then the new MAC address will be stored.

B.

The new source MAC addresses will not be entered in the VPLS service forwarding database.

C.

New local source MAC addresses will not be entered in the VPLS service forwarding database, but new remote MAC addresses would continue to be entered.

D.

New remote source MAC addresses will not be entered in the VPLS services forwarding database, but new local MAC addresses would continue to be entered.

Full Access
Question # 7

One of the shortcomings of Spanning Tree Protocol (STP) is that it computes a valid, but not necessarily optimal, path between nodes within a network.

A.

TRUE

B.

FALSE

Full Access
Question # 8

What option is available when using PBB to reduce the amount of required VPLS services?

A.

The Nokia 7750 SR supports 1:1 mapping of I-VPLS services to B-VPLS services.

B.

The Nokia 7750 SR supports 1:1 andM:1 mapping of l-VPLS services to B- VPLS services.

C.

The Nokia 7750 SR supports the mapping of multiple, standard VPLS services to B-VPLS services.

D.

The Nokia 7750 SR supports the mapping of multiple, standard VPLS services to l-VPLS services.

Full Access
Question # 9

What is the MTU impact on the SDP path-mtu if fast reroute, one-to-one mode is implemented on the LSP?

A.

There will be no impact on the path-mtu.

B.

The path-mtu will decrease by4 bytes.

C.

The path-mtu will increase by 4 bytes.

D.

The path-mtu will decrease by 8 bytes.

E.

The path-mtu will increase by 8 bytes.

Full Access
Question # 10

Which of the following is NOT a feature of the IEEE 802.3ah EFM standard?

A.

Discovery and auto-negotiation of OAM capabilities.

B.

Link monitoring via event notifications.

C.

Remote failure indication (RFI).

D.

Remote Loopback

E.

Latency and jitter across a service.

Full Access
Question # 11

Click on the exhibit below.

In the following diagram, traffic ingressing on SAP 1/2/3:1 will be passed to the layer-2 DPI device for inspection based on a filter policy applied to the ingress of the SAP. What feature should be enabled on SAP 1/2/1:100 and SAP 1/2/2:100 to ensure that incorrect information is not populated in the FDB of VPLS 1?

A.

Learning should be disabled on both SAPs connected to the DPI device to prevent FDB instability

B.

A MAC filter should be applied to both SAPs connected to the DPI to limit MAC learning on the port

C.

An IP filter should be applied to both SAPs connected to the DPI to prevent FDB instability

D.

The SAPs connected to the DPI should be configured with the "discard-unknown" feature to limit MAC learning on the port

Full Access
Question # 12

In IEEE 802.1ag, which two key functions are configured on bridge ports (SAPs and SDPs) to support CFM messages? (Choose 2)

A.

MEP

B.

MAP

C.

MIP

D.

MUP

Full Access
Question # 13

Click on the exhibit below.

CE-A sends frames with 2 tags. If the SAP on PE-A is "sap 1/1/1:1 .*" and the SAP on PE-B is "sap 1/1/1:100.200" how many tags will there be on the frame when it egresses from the SAP on PE-B?

A.

0

B.

1

C.

2

D.

3

Full Access
Question # 14

Which of the following features can be enabled to eliminate MAC instability when using policy-based forwarding to redirect traffic to a Layer 2 DPI device?

A.

discard-unknown

B.

mac-move

C.

disable-learning

D.

enable-mac-stability

Full Access
Question # 15

Click on the exhibit below.

Based on the service-mtu of this B-VPLS, what is the maximum service-mtu of any connecting I-VPLS attached to this B-VPLS?

A.

9100 bytes

B.

9104 bytes

C.

9108 bytes

D.

9118 bytes

Full Access
Question # 16

Which of the following functions must a PE router support when participating in a VPLS service? (Choose 3)

A.

MAC learning

B.

Frame replication

C.

Frame fragmentation

D.

Frame forwarding

E.

Must discard frames with an unknown destination MAC

F.

MSTP

Full Access
Question # 17

Fill in the blank for this next sentence. Flooded traffic received on any ____________ in the service is replicated to other spoke SDPs and SAPs and not transmitted on any mesh SDPs.

A.

Spoke SDP

B.

Mesh SDP

C.

Either (a) or (b) will make this sentence true.

D.

Neither (a) nor (b) will make this sentence true.

Full Access
Question # 18

If the command "disable-learning" has been added at the VPLS level, then MAC entries which have already been learned will not be aged.

A.

TRUE

B.

FALSE

Full Access
Question # 19

Which of the following statements about Spanning Tree Protocol is true?

A.

For the switches that are non-root or designated switches, the port with the highest combined cost to the root is the root port.

B.

In the case where two switches have the same priority, the switch with the lowest MAC address becomes the root.

C.

The switch port that is the greatest distance from the LAN to the root is the designated port.

D.

All of the above.

Full Access
Question # 20

During the process of troubleshooting a VPLS problem the "oam mac-purge" command with "register" option was used to purge a MAC address from the FDB. Which of the following statements is true?

A.

Relearning of the MAC address that was purged can only be done once customer traffic resumes.

B.

Relearning of the MAC address that was purged can only be done with the "oam mac-populate" command.

C.

Customer traffic destined to the MAC address that was purged will be dropped until the MAC address is relearned with the "oam mac-populate" command.

D.

Relearning of the MAC address that was purged can only be done with the "oam mac-register" command.

Full Access
Question # 21

Click on the exhibit below.

The MDU attached to this PE has been configured with active/standby SDP's configuration option has been configured for the PE to recognize that this SDP is in standby mode?

A.

On the PE the endpoint has been configured with "supress-standby-signalling"

B.

On the PE the endpoint has been configured with "no supress-standby-signalling"

C.

On the MDU the endpoint has been configured with "supress-standby-signalling"

D.

On the MDU the endpoint has been configured with "no supress-standby-signalling1

Full Access
Question # 22

Click on the exhibit below.

Assume PE-1 has a mesh-sdp configured to every PE node in both Metro networks. What could be done to prevent the bandwidth replication between Metro 1 and Metro 2?

A.

PE-1 must be configured with mesh-SDPs to every node receiving the multicast traffic. There is no way to reduce the replication or bandwidth.

B.

PE nodes in Metro 1 could be configured with mesh-SDPs. PE nodes in Metro 2 would be configured with mesh-SDPs. However, the connection between Metro networks (PE-2 to PE-6) can be configured with a spoke-sdp. This would reduce the replication and bandwidth used on the link between Metro networks. This also reduces the replication required by PE-1.

C.

PE-1 can be configured with spoke-SDPs to every PE node in both Metro networks. This will reduce the bandwidth and replication within the network.

D.

PE nodes in Metro 1 could be configured with spoke-SDPs. PE nodes in Metro 2 would be configured with spoke-SDPs. However, the connection between Metro networks (PE-2 to PE-6) can be configured with a mesh-sdp. This would reduce the replication and bandwidth used on the link between Metro networks. This also reduces the replication required by PE-1.

Full Access
Question # 23

What is the default remote-age timer of a B-VPLS?

A.

The same timer is used in all VPLS types.

B.

Higher than the default timer of an I-VPLS.

C.

Lower than the default timer of an l-VPLS.

D.

The same timer as an l-VPLS.

Full Access