300-425 Exam Dumps - Designing Cisco Enterprise Wireless Networks (ENWLSD)

Searching for workable clues to ace the Cisco 300-425 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s 300-425 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:

<< First
Prev
1
2
3
4
5
6
7
8
9
10
Next
Last >>

Question # 9

Which UDP port numbers are used for exchange mobility packets in an AireOS wireless deployment?

UDP 16666 for control plane, EoIP (IP protocol 97) for data plane

UDP 16668 for control plane, UDP 16667 for data plane

UDP 16667 for control plane, UDP 16666 for data plane

UDP 16666 for control plane, UDP 16667 for data plane

Full Access

Question # 10

A wireless engineer is designing a wireless network for a warehouse using access points with internal antennas. Which two elements have a negative effect on the wireless users? (Choose two.)

wireless channels

access point height

client authentication

client authorization

absorption

Full Access

Question # 11

A customer called with a requirement that internal clients must be on different subnets depending on the building they are in. All access points are operating in local mode and will not be modified, and this is a single controller solution. Which design approach creates the desired result?

Create AP groups for each desired location, map the correct VLANs to the internal SSID, and add the access points for that location.

Create an SSID place it to the desired VLAN under WLANs and configure 802.1x in ISE to assign the correct VLAN based on the SSID from which the client is authenticating

Create FlexConnect groups, place the access points in, and set the correct VLAN to SSID mapping based on location.

Create mobility anchors for the SSID and on the controller under the internal SSID create a foreign map to the desired VLAN based on location.

Full Access

Question # 12

A wireless engineer is using Ekahau site survey to validate that an existing wireless network is operating as expected, which type of survey should be using to identify the end-to-end network performance?

GPS assisted

Spectrum analysis

Passive

Active ping

Full Access

Question # 13

An engineer is configuring a centralized set of controllers for separate facilities. Which two Cisco wireless architectures must be used to ensure flexible sizing of WLAN to VLAN mappings? (Choose two.)

interface group

mobility group

AP group

controller group

RF group

Full Access

Question # 14

Which design consideration is most important for real-time applications such as voice and video over WLAN?

High data rates

Low latency and jitter

Maximum throughput

Use of DFS channels

Full Access

Question # 15

An engineer is deploying new APs to serve IEEE 802.11g through 802 11ac clients and wants to use the Ekahau Site Survey tool to verify RF coverage Management wants the engineer to verity and create coverage maps as quickly as possible. Which configuration accomplishes the goal?

active mode with two wireless adapters

passive mode with two wireless adapters

passive mode with one wireless adapter

active mode with one wireless adapter

Full Access

Question # 16

A 60,000-square-foot outdoor area must be surveyed. The survey must be completed in the least amount of time. Which tool or equipment is used when performing the site survey?

additional access points that use sniffer mode

site survey tool that has modules in sniffer mode

Additional access points that use GPS mode

site survey tool that has a GPS module

Full Access