300-425 Exam Dumps - Designing Cisco Enterprise Wireless Networks (ENWLSD)

For optimized roaming across multiple Wireless LAN Controllers (WLCs) with Cisco 8821 phones, configuring mobility groups between WLCs allows for seamless roaming and sharing of security contexts. Additionally, using Cisco Centralized Key Management (CCKM) for authentication reduces the time required for re-authentication during roaming, providing a more efficient transition between access points3

For Cisco Wireless LAN Controllers (WLCs) to operate in High Availability (HA) with Stateful Switch Over (SSO), they must be connected through a Redundancy Port (RP). This dedicated port is used for synchronization of stateful information and ensuring seamless failover without service interruption.

 In a scenario where a customer has multiple Wireless LAN Controllers (WLCs) running N+1 redundancy with Access Points (APs) equally distributed, the critical APs must have priority in case of a WLC failure. If critical APs remain unregistered during a WLC failure, it indicates that the AP failover priority is not enabled globally on the backup WLC. Enabling AP failover priority ensures that critical APs are given precedence over other APs, allowing them to register with the backup WLC first.

 The Cisco Aironet 3800 Series APs support mGig, which allows for higher throughput over existing cabling. However, the maximum cable length that supports 5G operation is limited by the quality of the cable and signal attenuation. Category 5e cabling can support 5G operation up to a length of 130 meters, which is within the acceptable range for maintaining the required signal integrity for 5G speeds.

In a high-density environment like an auditorium, where APs are in close proximity and a large number of devices are connected, the RF profile is used to adjust the radio frequencies of the APs to minimize co-channel interference. The RF profile allows for the configuration of power levels, channel width, and channel assignment to optimize wireless performance and reduce interference. References: CCNP Enterprise Wireless Design ENWLSD 300-425 and Implementation ENWLSI 300-430 Official Cert Guide Premium Edition and Practice

Raising the minimum data rate to 24 Mbps will reduce the range at which devices can connect, thereby reducing channel overlap. Using directional antennas can also help limit the coverage area of some APs, which can further reduce channel overlap by focusing the signal in specific directions rather than in a broad coverage pattern. References: Designing Cisco Enterprise Wireless Networks (ENWLSD 300-425)

To focus the coverage heat map on the desired coverage, the engineer should use the RSSI slider to set the heat map to the desired cutoff filter. This action will adjust the display to show only the signal levels that meet or exceed the specified RSSI value, effectively filtering out weaker signals and highlighting areas with sufficient coverage. References: Designing Cisco Enterprise Wireless Networks (ENWLSD 300-425)