A customer with a four-node RF2 cluster is adding application VMs to their system. After adding these VMs, the Prism dashboard shows 81% storage utilization.
What is the consequence of running the cluster at 81% storage utilization?
A system administrator needs to shut down an AHV node in a Nutanix cluster without causing service disruption. The administrator checks data resiliency and verifies that the cluster can tolerate a node down.
Which three steps should the administrator perform next? (Choose three.)
An administrator is responsible for the following Nutanix Enterprise Cloud environment:
• A central datacenter with a 20-node cluster with 1.5PB of storage
• Five remote sites each with a 4-node cluster with 200TB storage
The remote sites are connected to the datacenter via 1GB links with an average latency of 6 ms RTT. What is the minimum RPO the administrator can achieve for this environment?
Which Task is Required to initiate a live migration of VMs between two cluster.?
Which command should an administrator run from the CLI to view the uplink state of all AHV nodes in the cluster?
Refer to the exhibit.
A Microsoft SQL 2016 deployment is shown in the exhibit. The administrator receives user reports that database queries take too long to return.
Which optimization should be made to this configuration to improve performance?
A VM is exhibiting one or more of the following baseline values based on the past 30 days:
• CPU usage < 20%
• CPU ready time < 5%
• Memory usage < 50% (moderately) or < 20% (severely)
• Memory swap rate = 0 Kbps
Which type of VM is being described?
A Nutanix cluster is deployed with the following configuration:
• Three four-node blocks (A, B, and C)
• All Flash Redundancy Factor 2
What is the effect of simultaneous disk failures on two nodes located in block A?
An administrator is configuring software only. Data-at-Rest Encryption on their Nutanix cluster. They are planning to deploy a third-party key management server (KMS).
Where should this server be hosted?
What are two types of Protection Domains that Nutanix Offers for data Protection? Choose Two
In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.
The current schedule configuration is as follows:
• Repeat every 6 hours
• Local Retention Policy 1
• Remote Retention Policy 8
• Starting time 12 am
At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.
Which strategy should the administrator use to meet these requirements?
What is required to successfully live migrate a VM Between two AHV clusters?
The following alert appears on the file server alerts tab in the file server dashboard:
Which two events can generate this alert? (choose two)
An administrator wants to view VMs with NGT Installed and Filter by their installed guest operating systems.
How can this task most quickly be accomplished within prism central?
An administrator needs to make sure an RF3 cluster can survive a failure of two complete racks without negatively affecting performance. The current cluster configuration consists of the following:
• 30 All Flash Nodes: distributed 10 nodes per rack across three 42U racks
• Each node is configured with 20TB usable storage all flash (Cluster Total 600TB Usable)
• Current cluster utilization is 500TB storage
• Storage containers have Erasure Coding enabled
Which configuration changes should be made to make sure the cluster meets the requirements?
An organization subscribes to field advisories from the Nutanix support portal. An administrator receives an email about a rare problem that could cause cluster instability and affect the entire AOS cluster. The organization is running Vmware vsphere 6.x on Nutanix.
What action should be taken to resolve this issue?
A VDI environment based on AHV Cluster is not performing well. The current environment is using only one bridge (Bridge0). The administrator needs to verify if nodes are using all network cards associated to Bridge0.
Which two menus should be used to check the current configuration? (Choose two.)
An administrator recently added in 3 nodes to an existing 5 node cluster. While 1 node came with its own block, the other 2 nodes where added to an existing share. After adding the nodes, the administrator sees that the hardware tab displays the correct number of nodes, but incorrect position in the diagram tab.
What should the administrator do to resolve the issue?
In an AHV cluster, an administrator needs to enable an application to share a disk b group but needs to enable the VMs to see the volume group.
How should the administrator accomplish this task?
An administrator migrates a VM onto a new Nutanix cluster. After the migration, the administrator observes the following conditions:
• Cluster memory utilization: 64%
• Cluster CPU utilization: 19%
• Cluster storage utilization: 32%
• Average VM CPU utilization: 25%
• Average VM CPU ready%: 24%
• Average VM memory utilization: 60%
Which two changes should the administrator make to improve VM performance? (Choose two.)
An administrator is deploying a three-tier application on a Nutanix Enterprise Cloud consisting of web, application, and database VMs. Traffic between the servers must be limited to specific services/ports. There is an application layer firewall VM deployed on one host in the cluster.
In which way should the administrator meet this requirement?