Halloween Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: scxmas70

  1. Home
  2. HP
  3. Aruba Certified Switching Associate (ACSA) V1
  4. HPE6-A72 - Aruba Certified Switching Associate Exam

HPE6-A72 Exam Dumps - Aruba Certified Switching Associate Exam

Searching for workable clues to ace the HP HPE6-A72 Exam? You’re on the right place! ExamCert has realistic, trusted and authentic exam prep tools to help you achieve your desired credential. ExamCert’s HPE6-A72 PDF Study Guide, Testing Engine and Exam Dumps follow a reliable exam preparation strategy, providing you the most relevant and updated study material that is crafted in an easy to learn format of questions and answers. ExamCert’s study tools aim at simplifying all complex and confusing concepts of the exam and introduce you to the real exam scenario and practice it with the help of its testing engine and real exam dumps

Go to page:
Question # 9

What are two features in a 2-Tier design that are implemented at the Access layer? (Choose two.)

A.

VPN access

B.

WAN/MPLS connectivity

C.

Endpoint Access

D.

Deep packet inspection

E.

Power over Ethernet

Full Access
Question # 10

What are two primary concerns regarding layer two loops in a redundant topology? (Choose two.)

A.

routing loops

B.

costs associated with upgrading from copper to fiber

C.

multiple frame copies leading to instability of the MAC address table

D.

security issues with a redundant loop indicating to hackers that a back-door exists

E.

broadcast storms

Full Access
Question # 11

Refer to the exhibit.

All four switches in the diagram have been configured with the region name "Aruba1".

What two other MSTP configurations must match for switches within the same MST region? (Choose two.)

A.

MST region type

B.

MST Bridge ID

C.

MST version number

D.

MST revision number

E.

MST VLAN to instance mapping

Full Access
Question # 12

Which two commands will save the running-config so that changes will be loaded automatically on the next reboot? (Choose two.)

A.

write memory

B.

save

C.

copy config config1 config startup-config

D.

copy running-config startup-config

E.

copy running-config checkpoint boot-config

Full Access
Question # 13

Which two port characteristics must match between LAG interfaces? (Choose two.)

A.

Port number

B.

Duplex

C.

Member ID

D.

Media type

E.

Chassis number

Full Access
Question # 14

Refer to the exhibit

What is true regarding VLAN 50 according to the diagram above?

A.

VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.

B.

Since VLAN 50 has not been assigned to any enabled physical port, the status is down.

C.

VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.

D.

VLAN 50 was never added to the vlan-database and therefore is in a down state.

Full Access
Question # 15

Refer to the exhibit.

What command (output shown above) gives the optics serial number and part number information?

A.

show interface physical

B.

show interface transceiver

C.

show inventory

D.

show interface optics

Full Access
Question # 16

Refer to the exhibit

Which command on Access-2 port 1/1/4 will enable connectivity between PC-1 and Server-1 without any routing enabled in the network?

A.

Access-2 (config-if-1/1/4)# vlan access 1, 10, 20, 255

B.

Access-2 (config-if-1/1/4)# vlan access 20

C.

Access-2 (config-if-1/1/4)# vlan 20 untag 1/1/4

D.

Access-2 (config-if-1/1/4)# vlan trunk allow 1, 10, 255

Full Access
Go to page:

Hot Exams

PCNSE Dumps
AZ-900 Dumps
200-301 Dumps
350-401 Dumps
350-701 Dumps
AZ-104 Dumps
CS0-003 Dumps
N10-009 Dumps
SY0-701 Dumps
CAS-005 Dumps
PT0-003 Dumps
ZDTA Dumps