H35-460 Exam Dumps - HCS-5G RAN V1.0

100Mhz, 64T64 cell recommended to configure how much eCPRI connection bandwidth?

Compared with the NSA architecture, the advantage of the SA architecture is that it can better focus on which businesses

When debugging the NR base station through the near end of the USB flash drive, which of the following conditions will cause the RU indicator of the main control board to be in the "load failed" state?

gNodeB's baseband device BascbandEQM is an optional addition.

Under NSA networking, the X2 interface of gNB can be self-established based on S1 and U2000.

Which of the following 5C network evolution paths has the lowest deployment cost?

The bandwidth of PRACH in NR is fixed.

Which of the following veneers can be occluded?

The calculation formula of the absolute frequency point of the gNodeB cell is similar to that of LTE, and the value of â–³F is also the same.

What is the broadcast period of MIB messages in NR?

Which MML command is used to bind the physical sector of gNodeB to the RF AAU?

There is no clock interlock scenario between the base stations of NR and GL standards.

Execute "route add 10.10.10.0 mask 255.255.255.0 192.168.5.1 -p" in the cmd window of the test computer, which one describes the error below?

What is the maximum number of RANKS supported by CPE Pro?

Which of the passive WDM schemes for CRAN fronthaul is correctly described?

When gNode configures the S1 interface user plane link, you also need to obtain the port numbers of the local end and the peer end.

5G Huawei CPE How long does it take to press the reset button to restore factory settings?

CU/DU is set together, CU logical nodes and DU logical nodes will be added on the same BBU5900.

Before the gNode configuration is adjusted, in order to avoid alarm reporting and display in the network management foreground, the project status cannot be set to which of the following states?

Which of the following command objects must be configured in the 5G RAN2.0 gNodeB Wireless Data Module?

In order to support the NSA DC feature on the base station, which of the following options need to be configured?

5G RAN 2.0 version uplink and downlink decoupling feature deployment can be connected to which 4G main control boards?

What is the maximum number of UBBPwfl boards supported by BBU5900?

In the 5G network test, what is the recommended test distance between the CPE and the gNB on the terminal side?

Which of the following high-frequency communication uplink and downlink coverage imbalance solutions is correct?

In the NSA networking scenario, gNodeB does not need to configure the X2 interface.

For the description of NSA networking, which items are correct?

What are the supported subcarrier intervals for 5G RAN2.0 gNodeB cells?

The fan module of BBU3910 and BBU5900 is compatible.