H12-811_V1.0 Exam Dumps - HCIA-Datacom V1.0 Exam

Comprehensive Explanation: A routing table contains several key elements:

Cost: Also known as metric, this indicates the cost associated with reaching a specific destination, such as the number of hops or link speed.

Next-hop address: This is the IP address of the next device along the route that packets should be forwarded to.

Protocol: The routing protocol (e.g., OSPF, RIP) that determined the route.

Interface: The physical or logical interface through which the router sends packets to reach the destination.

Destination/Mask: The destination network or subnet and the associated subnet mask define the range of IP addresses for which this route is valid. These elements together allow routers to efficiently forward traffic to the correct destinations.

Detailed Explanation:The Time to Live (TTL) field in an IP packet is decremented by 1 each time the packet passes through a router. When the TTL reaches zero, the packet is discarded to prevent it from circulating indefinitely. (Reference: HCIA-Datacom Training Material, IP Packet Structure)

SNMPv1 uses Trap messages to send unsolicited notifications about network events (e.g., failures, threshold breaches).

Response (A): Sent as a reply to SNMP queries, not proactively.

Get-Next Request (C) and Get-Request (D): These are polling requests, not proactive alarms.

Thus, the correct answer is B (Trap).

Detailed Explanation:In a "one-armed routing" setup, a router with sub-interfaces can handle inter-VLAN routing by logically segmenting traffic within a single physical interface. In this configuration, each department (Administration and Finance) is assigned a different VLAN with separate sub-interfaces on Router R1.

In such a setup, communication between different VLANs (i.e., inter-VLAN routing) is handled by the router, even without Proxy ARP enabled. The router can directly route packets between the VLANs as it is aware of the different networks and performs Layer 3 forwarding based on the IP address of each VLAN's sub-interface.

Thus, even if ARP Proxy is disabled, devices in the Administration and Finance departments can communicate through the router because inter-VLAN routing takes place at Layer 3 without relying on ARP proxy functionality​​​.

Understanding Timers:

Forward Delay Timer: Default value is 15 seconds, not 20 seconds.

Max Age Timer: Default value is 20 seconds.

Hello Timer: The default interval is 2 seconds for BPDU transmission.

Switch Role:

The output indicates that the switch is not the root bridge, confirming option D is correct.

Conclusion:

Statement A is incorrect as the Forward Delay timer is not 20 seconds.

References: HCIA-Datacom V1.0 Certification Guide, Chapter 8: Spanning Tree Protocol.

The telnetlib module in Python provides functions to interact with Telnet servers, allowing Python scripts to automate Telnet sessions. This module is widely used in network automation and scripting tasks, where Telnet is used to access and manage network devices remotely​.