350-601 Exam Dumps - Implementing Cisco Data Center Core Technologies (350-601 DCCOR)
Which two components should be checked when a Cisco Nexus 9000 Series Switch fails to boot using POAP? (Choose two.)
An engineer must implement a disaster recovery policy for the Cisco UCS infrastructure. The solution must meet these criteria
The Recovery Point Objective must be 48 hours
The backup must use encrypted transmission
The Recovery Time Objective must be 4 hours
Which configuration set must be used in the scheduled backup to meet these requirements?
Refer to the exhibit. An engineer must send all traffic passing through interface fc1/1 on N9K_1 to the monitoring laptop using a SPAN session. This configuration has already been applied to Cisco UCS Manager. Which additional set of actions must be taken to accomplish this goal?
Which configuration statically assigns VSAN membership to a virtual Fibre Channel interface?
Refer to the exhibit. Users report SAN traffic packet loss on a blade server that is managed by using Cisco UCS Manager. An engineer must implement a SPAN feature to an external Fibre Channel analyzer. Which configuration source in the TEST monitoring session must the engineer select?
An engineer must configure a named VSAN when the fabric interconnect is in Fibre Channel switch mode The VSAN must meet these requirements:
Named VSAN must be called "VSAN 10".
VSAN ID must be 10.
FCoE ID must be 20.
VSAN 10 must be attached to port 2 in slot 1.
Which command set configures a VSAN when the fabric interconnect is in Fibre Channel switch mode?
Refer to the exhibit. A network engineer must monitor the traffic from the server on VLAN 80.
All source traffic from the server must be captured on the monitoring device. Which configuration set meets these requirements?
Refer to the exhibit.
Which command is run from the Guest Shell to set the
description on the first five interfaces of the Cisco Nexus switch?