300-715 Exam Dumps - Implementing and Configuring Cisco Identity Services Engine (SISE) v4.0 (300-715 SISE)

An engineer is starting to implement a wired 802.1X project throughout the campus. The task is to ensure that the authentication procedure is disabled on the ports but still allows all endpoints to connect to the network. Which port-control option must the engineer configure?

A security engineer configures a Cisco Catalyst switch to use Cisco TrustSec. The engineer must define the PAC key to authenticate the switch to Cisco IISE. Drag and drop the commands from the left into sequence on the right. Not all options are used.

An organization is hosting a conference and must make guest accounts for several of the speakers attending. The conference ended two days early but the guest accounts are still being used to access the network. What must be configured to correct this?

Which two values are compared by the binary comparison (unction in authentication that is based on Active Directory?

Which compliance status is set when a matching posture policy has been defined for that endpomt. but all the mandatory requirements during posture assessment are not met?

An administrator is troubleshooting an endpoint that is supposed to bypass 802 1X and use MAB. The endpoint is bypassing 802.1X and successfully getting network access using MAB. however the endpoint cannot communicate because it cannot obtain an IP address. What is the problem?

An administrator is attempting to replace the built-in self-signed certificates on a Cisco ISE appliance. The CA is requesting some information about the appliance in order to sign the new certificate. What must be done in order to provide the CA this information?

An administrator is configuring a new profiling policy in Cisco ISE for a printer type that is missing from the profiler feed The logical profile Printers must be used in the authorization rule and the rule must be hit. What must be done to ensure that this configuration will be successful^